DF38602RFT10 Renesas Electronics America, DF38602RFT10 Datasheet - Page 133

• Manufacturer Part Number: DF38602RFT10
• Description: MCU 3V 16K 32-QFN
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H SLPr

Specifications of DF38602RFT10

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: I²C, IrDA, SCI, SSU
• Peripherals: POR, PWM, WDT
• Number Of I /o: 13
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 32-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F38602RFT10; HD64F38602RFT10

The features of the 16-Kbyte flash memory built into the flash memory (F-ZTAT) version are
summarized below.
• Programming/erasing methods
• On-board programming
• Automatic bit rate adjustment
• Programming/erasing protection
• Power-down mode
• Module standby mode
Note: The system clock oscillator must be used when programming or erasing the flash memory.
ROM3560A_000120030300
The flash memory is programmed 128 bytes at a time. Erasure is performed in single-block
units. The flash memory is configured as follows: 1 Kbyte × 4 blocks and 12 Kbytes × 1 block.
To erase the entire flash memory, each block must be erased in turn.
On-board programming/erasure can be done in boot mode, in which the boot program built
into this LSI is started to erase or program of the entire flash memory. In normal user program
mode, individual blocks can be erased or programmed.
For data transfer in boot mode, this LSI's bit rate can be automatically adjusted to match the
transfer bit rate of the host.
Sets software protection against flash memory programming/erasure.
Operation of the power supply circuit can be partly halted in subactive mode. As a result, flash
memory can be read with low power consumption.
Use of module standby mode enables this module to be placed in standby mode independently
when not used. (For details, refer to section 5.4, Module Standby Function.) However, when
using the on-chip emulator debugger, set the FROMCKSTP bit in clock halt register 1 to 1.
Section 6 ROM
Rev. 3.00 May 15, 2007 Page 99 of 516
REJ09B0152-0300
Section 6 ROM