MOD5272-100IR NetBurner Inc, MOD5272-100IR Datasheet - Page 397

• Manufacturer Part Number: MOD5272-100IR
• Description: PROCESSOR MODULE FLASH MOD5272
• Manufacturer: NetBurner Inc
• Type: Controllers & Processorsr

Specifications of MOD5272-100IR

• Module/board Type: Processor Module
• Ethernet Connection Type: 10/100 Ethernet Port RJ-45
• Operating Voltage: 3.3 V
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: MOD5272
• For Use With: 528-1001 - KIT DEVELOP NETWORK FOR MOD5272
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 528-1008

MOTOROLA
Chapter 17
General Purpose I/O Module
This chapter describes the operation and programming model of the three
general-purpose I/O (GPIO) ports on the MCF5272. It includes details about pin
assignment, direction-control, and data registers..
17.1 Overview
The MCF5272 provides up to 48 general-purpose I/O signals. The GPIO signal
multiplexing is shown in Table 17-1. All GPIO pins are individually programmable as
inputs or outputs. At reset, all configurable multifunction GPIO pins default to general
purpose inputs and all multifunction pins that are not shared with a GPIO pin default to high
impedance. To avoid indeterminate read values and reduce power consumption, internal
pull-up resistors are active immediately upon reset, and remain active until the
corresponding port direction registers are programmed.
The general-purpose I/O signals are configured as three ports, each having up to 16 signals.
These three general-purpose I/O ports are shared with other signals as follows:
Control registers for each port select the function (GPIO or peripheral pin) assigned to each
pin. Pins can have as many as four functions including GPIO. There is no configuration
register for GPIO port C because its pins are configured by WSEL during device reset.
An additional port, port D, has only a control register which is used to configure the pins
that are not multiplexed with any GPIO signals.
PA[6:0]
PA7
PA[15:8]
PB[7:0]
PB[15:8]
PC[15:0]
GPIO Signal
external USB transceiver interface signals
QSPI_CS3 and DOUT3
PLIC TDM ports 0 and 1
UART1 signals and the bus control signal TA
Ethernet controller signals
data bus signals D[15:0]. These are only available (as GPIO) when the device is
configured for 16-bit data bus mode using the WSEL signal
Table 17-1. GPIO Signal Multiplexing
Chapter 17. General Purpose I/O Module
Also Multiplexed on the Same Pins
17-1