UPD70F3786GJ-GAE-AX Renesas Electronics America, UPD70F3786GJ-GAE-AX Datasheet - Page 1293

• Manufacturer Part Number: UPD70F3786GJ-GAE-AX
• Description: MCU 32BIT V850ES/JX3-E 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Er

Specifications of UPD70F3786GJ-GAE-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, CSI, EBI/EMI, Ethernet, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 124K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(7) UF0 EP7 status register L (UF0E7SL)
UF0E7SL
Bit position
This register stores the value that is to be returned in response to the GET_STATUS Endpoint7 request.
This register can be read or written in 8-bit units. Note, however, that data can be written to this register only
when the EP0NKA bit is set to 1.
If an error occurs in Endpoint7, the E7HALT bit is set to 1. A write access to this register is ignored while a
USB-side access to Endpoint7 is being received.
The hardware automatically transmits the contents of this register to the host when it has received the
GET_STATUS Endpoint7 request. If Endpoint7 has stalled, the UF0INT1 register is cleared and the IT1NK bit
is cleared to 0.
Because writing this register is always masked when transfer to Endpoint7, rather than control transfer, is
executed, be sure to check this register to see if data has been correctly written to it.
Caution To rewrite this register, set the EP0NKA bit to 1 before reading the register contents, and
0
0
7
rewrite the register contents after confirming that the bit has been set, in order to prevent
conflict between a read access and a write access.
E7HALT
Bit name
6
0
CHAPTER 22 USB FUNCTION CONTROLLER (USBF)
This bit indicates the status of Endpoint7.
This bit is set to 1 by hardware when the SET_FEATURE Endpoint7 request has been
received. It is cleared to 0 by hardware when the CLEAR_FEATURE Endpoint7 request,
SET_CONFIGURATION request, or the SET_INTERFACE request for the Interface to
which Endpoint7 is linked has correctly been received. DATA PID is initialized to DATA0.
5
0
1: Stalled
0: Not stalled
4
User’s Manual U19601EJ2V0UD
0
3
0
2
0
Function
1
0
E7HALT
0
00200168H
Address
After reset
00H
1291