BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 716

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Description
Mode
3.20.3
to be used from data sources and circuits shown in the table below.
LDACR1<OPMODE[4:0]>.
This section describes each operation mode of the LCDDA.
The LCDDA realizes each mode by combining appropriate original image data and circuits
The following operation modes are available, which can be selected through
Each operation mode is described in detail on the pages that follow.
Image data only
superimposing
Note 1: The BC_Expander and Blender cannot be used simultaneously.
Note 2: Source0 and Source1 are not used in the scaler mode.
Operation Description of Each Mode
Source0
used for
(Note 2)
NORMAL mode
Scaler mode
Monochrome mode
Monochrome invert mode
BLEND mode
Monochrome BLEND mode
Monochrome invert BLEND mode
Original Image Data
Operation Mode
for superimposing
Image data used
and simple
Source1
(Note 2)
transfer
down display
Scales up or
Expander
TENTATIVE
TMPA900CM- 715
data.
BC
Performs simple data transfer.
Controls the BC-Expander circuit to scale up or down image data.
Transfers monochrome source data.
Inverts and transfers monochrome source data.
This mode is the same as the monochrome mode except that
monochrome data is inverted in color conversion.
Blends two color (16 bpp/24 bpp) pictures.
Blends a monochrome picture and a color (16 bpp/24 bpp) picture.
This mode is used to convert a monochrome S1 picture into color
and then blend it with a color picture.
Two-valued (monochrome) FONT data can also be superimposed
over a color picture.
Blends an inverted monochrome picture and a color (16 bpp/24
bpp) picture. This mode is the same as the monochrome BLEND
mode except that monochrome data is inverted in color
conversion. By using two-valued (monochrome) data, only
negative portion of a monochrome picture can be superimposed
over a color picture.
Performs color
Converter
conversion.
Color
superimposed.
Filters areas
Area Filter
Circuits Used
Description
Blender
to be
Superimposer
superimposing.
Performs
TMPA900CM
2009-10-14
Performs rotation
Control Circuit
scaling down.
and simple
Transfer
Address