BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 606

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

bmRequestType
0y00000000
• Default state:
• Address state:
• Configured state: Nothing is specified for the operation of devices by the USB 2.0
(d) Set Address request
STATUS-Stage has ended.
When wValue = 0
Keeps the default state. No register access to UDC2 is required.
When wValue ≠ 0
Set wValue to bits 6-0 (dev_adr) and 0y010 to bits 10-8 (Device_State) of Address-State
register. UDC2 will be put in the address state.
When wValue = 0
Set 0x00 to bits 6-0 (dev_adr) and 0y001 to bits 10-8 (Device_State) of Address-State
register. UDC2 will be put in the Default state.
When wValue ≠ 0
Set wValue to bits 6-0 (dev_adr) of Address-State register.
UDC2 will be set to the new device address.
For this request, make register accesses shown below within 2 ms after the
(The device address should not be changed before the Setup_Fin command is issued.)
To this request, device addresses are set.
SET_ADDRESS
bRequest
specification.
TENTATIVE
TMPA900CM- 605
Device Address
wValue
wIndex
Zero
wLength
Zero
TMPA900CM
2009-10-14
Data
None