BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 491

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.16.2.4 Terms and Presentation
Assert
Deasset
Word
Byte
UDC2
UDC2AB
Endpoint
Rx-EP
Tx-EP
Endpoint I/F
PVCI I/F
Master transfer
Target device
Master Write transfer
Master Read transfer
Slave transfer
USB_RESET
NULL packet
PHY
Interrupt
: Indicates the signal is active.
: Indicates the signal is inactive.
: 32 bits
: 8 bits
: Indicates the USB2.0 device controller to be connected to UDC2AB.
: This IP: Abbreviation of UDC2-AHB-Bridge
: FIFO held by UDC2 for communication with the USB host. Abbreviated as “EP”.
: Receive endpoint. For the OUT transfer of USB transfer (USB host to USB
: Transmit endpoint. For the IN transfer of USB transfer (USB device to USB host).
: DMA interface dedicated to the endpoints held by UDC2.
: Common interface held by UDC2. Used for accessing the internal registers of
: Indicates that UDC2AB acquires the bus right to make transfer.
: Indicates the device (such as memories) to be accessed by UDC2AB with master
: Indicates the transfer with Rx-EP made by UDC2AB.
: Indicates the master transfer with Tx-EP made by UDC2AB.
: Indicates the transfer made by other devices than UDC2AB targeted at UDC2AB.
: Bus reset sent from the USB host. "Reset Signaling" in the USB specification.
: 0-length data to be transferred on USB.
: USB 2.0 PHY
: Indicates the INTS [21] output signal. Descriptions like "Assert xx interruption" in
device).
this document are based on the assumption that the relevant bit of the Interrupt
Enable resistor is enabled. See section 3.16.2.7 “Interrupt Signal (INTS[21])" for
more information.
UDC2
transfer.
TENTATIVE
TMPA900CM- 490
TMPA900CM
2009-10-14