BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 561

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

b. <ep_bi_mode>
c.
d. <suspend>
e. <configured>, <addressed>, <default>
f.
Selects whether to use the endpoint bidirectionally as a driver.
Setting this bit to 1 will enable an endpoint number to be used bidirectionally in USB
communication.
0y0: Single direction
0y1: Dual direction
<cur_speed[1:0]>
Indicates the present transfer mode on the USB bus.
0y00: Reserved
0y01: Full-Speed
0y10: High-Speed
0y11: Reserved
Indicates whether or not UDC2 is in suspended state.
0y0: Normal
0y1: Suspended
Set the present device state of UDC2. This should be set in accordance with the request
received from the host. Please note that you should not set 1 to more than one bit.
<dev_adr[6:0]>
Sets the device address assigned by the host.
The device address should be set after Set_address has finished normally (after
STATUS-Stage finished normally).
0y001: default (to be set when the DeviceAddress = 0 was specified by the Set_address
0y010: addressed (to be set when ConfigurationVallue = 0 was specified by the
0y100: configured (to be set when the Set_config request is received)
request in Default/Address state (this will be set by the hardware when
USB_RESET is received))
Set_configuration request after the Set_address request finished normally and
in the Address/Configured state)
TENTATIVE
TMPA900CM- 560
TMPA900CM
2009-10-14