BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 560

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

[31:16]
[15]
[14]
[13:12]
[11]
[10]
[9]
[8]
[7]
[6:0]
Bit
[Description]
stage_err
ep_bi_mode
cur_speed[1:0]
Suspend
Configured
Addressed
Default
−
dev_adr[6:0]
−
a. <stage_err>
Note 1: The initial value of cur_speed[1:0] (bits [13:12]) after USB_RESET is “0y10” (high-Speed) if the Chirp
Note 2 : About TMPA900CM, EP0: single direction / dual direction . EP1, EP2 and EP3: single direction. only
Symbol
Indicates whether Control transfers finished normally up to the STATUS-Stage.
1 will be set when the Setup-Token is received in DATA-Stage/STATUS-Stage or in the
case of “STALL” transmission. When set, it will be cleared when the next Control transfer
has been finished normally.
0y0: Other than above conditions
0y1: Received the Setup-Token in DATA-Stage/STATUS-Stage or “STALL” transmission.
(1) Device Status Registers
1.
Bit
sequencehas been sucessful, and “0y01” (Full-Speed) if it has failed.
UD2ADR (Address-State register)
−
RO
R/W
RO
RO
R/W
R/W
R/W
−
R/W
Type
Undefined
0y0
0y0, (-)
0y01,(Note1)
0y0
0y0
0y0
0y0,(1)
Undefined
0y0000000
TENTATIVE
TMPA900CM- 559
Reset
Value
Read as undefined. Write as zero.
Indicates whether Control transfers finished normally up to
the STATUS-Stage.
0y0: Other than below conditions
0y1: Received the Setup-Token in
Selects whether to use the endpoint bidirectionally as a
driver. (Note 2)
0y0: Single direction
0y1: Dual direction
Indicates the present transfer mode on the USB bus.
0y00: Reserved
0y10: High-Speed
Indicates whether or not UDC2 is in suspended state.
0y0: Normal,
Sets the present device state of UDC2.
0y001:Default (to be set when the DeviceAddress=0 was
0y010:Addressed (to be set when ConfigurationVallue = 0
0y100:Configured (to be set when the Set_config request is
Read as undefined. Write as zero.
Sets the device address assigned by the host.
DATA-Stage/STATUS-Stage or "STALL" transmission.
specified by the Set_address request in
Default/Address state (this will be set by the hardware
when USB_RESET is received))
was specified by the Set_configuration request after the
Set_address request finished normally and in the
Address/Configured state)
received)
Address = (0xF440_0000) + (0x0200)
Description
0y01: Full-Speed
0y11: Reserved
0y1: Suspended
TMPA900CM
2009-10-14