sc9s12hy64j0vllr Freescale Semiconductor, Inc, sc9s12hy64j0vllr Datasheet - Page 699

• Manufacturer Part Number: sc9s12hy64j0vllr
• Description: S12 Microcontrollers Mcu 16-bit Hcs12 Cisc 32kb Flash 5v Tray
• Manufacturer: Freescale Semiconductor, Inc

Whenever FAST = 0 only 16-bit write accesses to the duty cycle registers are allowed, 8-bit write accesses
can lead to unpredictable duty cycles.
While fast mode is enabled (FAST = 1), 8-bit write accesses to the high byte of the duty cycle registers are
allowed, because only the high byte of the duty cycle register is used to determine the duty cycle.
The following sequence should be used to update the current magnitude and direction for coil 0 and coil
1 of the motor to achieve consistent PWM output:
At the next timer counter overflow, the duty cycle registers will be copied to the working duty cycle
registers. Sequential writes to the duty cycle register x will result in the previous data being overwritten.
19.4.1.1.2
In full H-bridge mode, the PWM channels x and x + 1 operate independently. The duty cycle working
registers are updated whenever a timer counter overflow occurs.
19.4.1.1.3
In half H-bridge mode, the PWM channels x and x + 1 operate independently. In this mode, each PWM
channel can be configured such that one pin is released and the other pin is a PWM output.
shows a typical configuration in half H-bridge mode.
The two pins associated with each channel are switchable between released mode and PWM output
dependent upon the state of the MCOM[1:0] bits in the MCCCx (channel control) register. See register
description in
state of the S bit has no effect.
Freescale Semiconductor
1. Write to duty cycle register x
2. Write to duty cycle register x + 1.
PWM Channel x + 1
PWM Channel x
Section 19.3.2.4, “Motor Controller Channel Control
Full H-Bridge Mode (MCOM = 10)
Half H-Bridge Mode (MCOM = 00 or 01)
Figure 19-10. Typical Dual Full H-Bridge Mode Configuration
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
MnC0P
MnC0M
MnC1P
MnC1M
Registers”. In half H-bridge mode, the
Motor n, Coil 0
Motor Controller (MC10B8CV1)
Motor n, Coil 1
Figure 19-11
699