sc9s12hy64j0vllr Freescale Semiconductor, Inc, sc9s12hy64j0vllr Datasheet - Page 142

• Manufacturer Part Number: sc9s12hy64j0vllr
• Description: S12 Microcontrollers Mcu 16-bit Hcs12 Cisc 32kb Flash 5v Tray
• Manufacturer: Freescale Semiconductor, Inc

S12P Memory Map Control (S12PMMCV1)
Please note that after the MCU enters active BDM mode the BDM firmware lookup tables and the BDM
registers will also be visible between addresses 0xBF00 and 0xBFFF if the PPAGE register contains value
of 0x0F.
3.4.2.1.1
Expansion of the Local Address Map
Expansion of the CPU Local Address Map
The program page index register in S12PMMC allows accessing up to 256KB of P-Flash in the global
memory map by using the four index bits (PPAGE[3:0]) to page 16x16 KB blocks into the program page
window located from address 0x8000 to address 0xBFFF in the local CPU memory map.
The page value for the program page window is stored in the PPAGE register. The value of the PPAGE
register can be read or written by normal memory accesses as well as by the CALL and RTC instructions
(see
Section 3.6.1, “CALL and RTC
Instructions).
Control registers, vector space and parts of the on-chip memories are located in unpaged portions of the
64KB local CPU address space.
The starting address of an interrupt service routine must be located in unpaged memory unless the user is
certain that the PPAGE register will be set to the appropriate value when the service routine is called.
However an interrupt service routine can call other routines that are in paged memory. The upper 16KB
block of the local CPU memory space (0xC000–0xFFFF) is unpaged. It is recommended that all reset and
interrupt vectors point to locations in this area or to the other unmapped pages sections of the local CPU
memory map.
Expansion of the BDM Local Address Map
PPAGE and BDMPPR register is also used for the expansion of the BDM local address to the global
address. These registers can be read and written by the BDM.
The BDM expansion scheme is the same as the CPU expansion scheme.
The four BDMPPR Program Page index bits allow access to the full 256KB address map that can be
accessed with 18 address bits.
The BDM program page index register (BDMPPR) is used only when the feature is enabled in BDM and,
in the case the CPU is executing a firmware command which uses CPU instructions, or by a BDM
hardware commands. See the BDM Block Guide for further details. (see
Figure
3-9).
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
142
Freescale Semiconductor