LSI53C825AJ LSI, LSI53C825AJ Datasheet - Page 66

• Manufacturer Part Number: LSI53C825AJ
• Manufacturer: LSI

Specifications of LSI53C825AJ

• Lead Free Status / RoHS Status: Not Compliant

2.4.14 Chained Block Moves
2.4.14.1 Wide SCSI Send Bit
2.4.14.2 Wide SCSI Receive Bit
2-42
Since the LSI53C825A has the capability to transfer 16-bit wide SCSI
data, a unique situation occurs when dealing with odd bytes. The
chained move (CHMOV) SCRIPTS instruction along with the Wide SCSI
Send (WSS) and Wide SCSI Receive (WSR) bits in the
Two (SCNTL2)
The WSS bit is set whenever the SCSI controller is sending data
(Data-Out for initiator or Data-In for target) and the controller detects a
partial transfer at the end of a chained Block Move SCRIPTS instruction
(this flag is not set if a normal Block Move instruction is used). Under this
condition, the SCSI controller does not send the low-order byte of the last
partial memory transfer across the SCSI bus. Instead, the low-order byte
is temporarily stored in the lower byte of the
(SODL)
flag to determine what behavior must occur at the start of the next data
send transfer. When the WSS flag is set at the start of the next transfer,
the first byte (the high-order byte) of the next data send transfer is
“married” with the stored low-order byte in the
(SODL)
regardless of the type of Block Move instruction (normal or chained). The
flag is automatically cleared when the “married” word is sent. The flag is
alternately cleared through SCRIPTS or by the microprocessor.
Additionally, this bit can be used by the microprocessor or SCRIPTS for
error detection and recovery purposes.
The WSR bit is set whenever the SCSI controller is receiving data
(Data-In for initiator or Data-Out for target) and the controller detects a
partial transfer at the end of a block move or chained block move
SCRIPTS instruction. When WSR is set, the high-order byte of the last
SCSI bus transfer is not transferred to memory. Instead, the byte is
temporarily stored in the
hardware uses the WSR bit to determine what behavior must occur at
the start of the next data receive transfer. The bit is automatically cleared
at the start of the next data receive transfer. The bit can alternatively be
Functional Description
register and the WSS flag is set. The hardware uses the WSS
register; and the two bytes are sent out across the bus,
register are used to facilitate these situations.
SCSI Wide Residue (SWIDE)
SCSI Output Data Latch
SCSI Output Data Latch
register. The
SCSI Control