TMPM330FWFG Toshiba, TMPM330FWFG Datasheet - Page 75

• Manufacturer Part Number: TMPM330FWFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 128K FLASH, 8K SRAM
• Manufacturer: Toshiba

Specifications of TMPM330FWFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 3V
• Cpu Mhz: 40
• Ssp (ch) Spi: -
• I2c/sio (ch): 3
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: -
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: 12
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 10
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit
• Lead Free Status / Rohs Status: Details

8.5.1.2
8.5.1.3
・From external pin
・From peripheral function
・By setting Interrupt Set-Pending Register (forced pending)
interrupt source or by setting the NVIC’s Interrupt Set-Pending Register.
Register.
is used to clear a standby mode.
transmitted to the CPU via the clock generator. For these interrupt sources, appropriate settings
must be made in the clock generator in advance. External interrupt sources not used for clearing a
standby mode can be used without setting the clock generator.
Set the peripheral function to make it possible to output interrupt requests.
See the chapter of each peripheral function for details.
An interrupt request is generated from an external pin or peripheral function assigned as an
Set the port control register so that the external pin can perform as an interrupt function pin.
An interrupt request can be generated by setting the relevant bit of the Interrupt Set-Pending
An interrupt signal from an external pin or peripheral function is directly sent to the CPU unless it
Interrupt requests from interrupt sources that can be used for clearing a standby mode are
Generation
Transmission
Under development
Page63
TMPM330