HD64F2612FA20 Renesas Electronics America, HD64F2612FA20 Datasheet - Page 485

• Manufacturer Part Number: HD64F2612FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2612FA20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 43
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

16.7.4
If the conditions below are not met, the reliability of the device may be adversely affected.
• Analog input voltage range
• Relationship between AVcc, AVss and Vcc, Vss
16.7.5
In board design, digital circuitry and analog circuitry should be as mutually isolated as possible,
and layout in which digital circuit signal lines and analog circuit signal lines cross or are in close
proximity should be avoided as far as possible. Failure to do so may result in incorrect operation
of the analog circuitry due to inductance, adversely affecting A/D conversion values. Also, digital
circuitry must be isolated from the analog input signals (AN0 to AN11), and analog power supply
(AVcc) by the analog ground (AVss). Also, the analog ground (AVss) should be connected at one
point to a stable digital ground (Vss) on the board.
16.7.6
A protection circuit should be connected in order to prevent damage due to abnormal voltage, such
as an excessive surge at the analog input pins (AN0 to AN11), between AVcc and AVss, as shown
in figure 16.7. Also, the bypass capacitors connected to AVcc and the filter capacitor connected to
AN0 to AN11 must be connected to AVss.
If a filter capacitor is connected, the input currents at the analog input pins (AN0 to AN11) are
averaged, and so an error may arise. Also, when A/D conversion is performed frequently, as in
scan mode, if the current charged and discharged by the capacitance of the sample-and-hold circuit
in the A/D converter exceeds the current input via the input impedance (R
the analog input pin voltage. Careful consideration is therefore required when deciding circuit
constants.
The voltage applied to analog input pin ANn during A/D conversion should be in the range
AVss ≤ V
Set AVss = Vss as the relationship between AVcc, AVss and Vcc, Vss. If the A/D converter is
not used, the AVcc and AVss pins must not be left open.
Range of Analog Power Supply and Other Pin Settings
Notes on Board Design
Notes on Noise Countermeasures
AN
≤ AVcc.
Rev. 7.00 Sep. 11, 2009 Page 449 of 566
Section 16 A/D Converter
in
), an error will arise in
REJ09B0211-0700