HD64F2612FA20 Renesas Electronics America, HD64F2612FA20 Datasheet - Page 462

• Manufacturer Part Number: HD64F2612FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2612FA20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 43
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 15 Controller Area Network (HCAN)
HCAN sleep mode is entered by setting the HCAN sleep mode bit (MCR5) to 1 in the master
control register (MCR). If the CAN bus is operating, the transition to HCAN sleep mode is
delayed until the bus becomes idle.
Either of the following methods of clearing HCAN sleep mode can be selected:
• Clearing by software
• Clearing by CAN bus operation
Eleven recessive bits must be received after HCAN sleep mode is cleared before CAN bus
communication is re-enabled.
Clearing by Software: HCAN sleep mode is cleared by writing a 0 to MCR5 from the CPU.
Clearing by CAN Bus Operation: The cancellation method is selected by the MCR7 bit setting
in MCR. Clearing by CAN bus operation occurs automatically when the CAN bus performs an
operation and this change is detected. In this case, the first message is not stored in a mailbox;
messages will be received normally from the second message onward. When a change is detected
on the CAN bus in HCAN sleep mode, the bus operation interrupt flag (IRR12) is set in the
interrupt register (IRR). If the bus interrupt mask (IMR12) in the interrupt mask register (IMR) is
set to the interrupt enable value at this time, an interrupt can be sent to the CPU.
Rev. 7.00 Sep. 11, 2009 Page 426 of 566
REJ09B0211-0700