EP1S10F484I6 Altera, EP1S10F484I6 Datasheet - Page 795

• Manufacturer Part Number: EP1S10F484I6
• Description: IC STRATIX FPGA 10K LE 484-FBGA
• Manufacturer: Altera
• Series: Stratix®r

Specifications of EP1S10F484I6

• Number Of Logic Elements/cells: 10570
• Number Of Labs/clbs: 1057
• Total Ram Bits: 920448
• Number Of I /o: 335
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 484-FBGA
• Family Name: Stratix
• Number Of Logic Blocks/elements: 10570
• # I/os (max): 335
• Frequency (max): 450.05MHz
• Process Technology: 0.13um (CMOS)
• Operating Supply Voltage (typ): 1.5V
• Logic Cells: 10570
• Ram Bits: 920448
• Operating Supply Voltage (min): 1.425V
• Operating Supply Voltage (max): 1.575V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 484
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Not Compliant

Altera Corporation
September 2004
Page select
Current
configuration
(AnF)
Illegal values
Table 12–8. Parameter Settings for the altremote_update Megafunction (Part 2 of 2)
Parameter
Selected
param[2..0]
bit setting
100
101
001
110
111
Remote Update WYSIWYG ATOM
An alternative to using the altremote_update megafunction is to
directly instantiate the remote update WYSIWYG atom. This atom should
be included in the factory configuration and any application
configuration image to access the remote configuration shift registers.
When implementing the atom, you should consider following:
1.
2.
3.
4.
parameter
width of
Only one atom can be used in the circuit; more than one gives a
no-fit.
All signals for the cell must be connected. The clock port (CLK) must
be connected to a live cell. The others can be constant V
The pgmout port must be connected and must feed PGM[2.0]
output pins (it cannot be connected to anything else but output
pins).
The Quartus II software reserves RUnLU as an input pin, and you
must connect it to V
value
3
1
Remote System Configuration with Stratix & Stratix GX Devices
3 bit '001' - Local
1 bit '0' - Factory Specifies whether the current configuration is
configuration
configuration
POR Reset
3 bit '000' -
Application
1 bit '1' -
Remote
Value
CC
.
Page mode selection. Writing of this parameter
is only allowed when in the factory
configuration.
factory or and application configuration. This
parameter can only be read.
Stratix Device Handbook, Volume 2
Description
CC
or GND.
12–17