MC68302EH20C Freescale Semiconductor, MC68302EH20C Datasheet - Page 463

• Manufacturer Part Number: MC68302EH20C
• Description: IC MPU MULTI-PROTOCOL 132-PQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68302EH20C

• Processor Type: M683xx 32-Bit
• Speed: 20MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 132-MQFP, 132-PQFP
• Family Name: M68000
• Device Core: ColdFire
• Device Core Size: 32b
• Frequency (max): 20MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 5V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 132
• Package Type: PQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Compliant

E.3.2.2 GENERAL AND TRANSPARENT PROTOCOL-SPECIFIC RAM INITIALIZATION.
E.3.2.3 SCC INITIALIZATION.
E.3.2.4 SCC OPERATION.
E.3.2.5 SCC INTERRUPT HANDLING.
MOTOROLA
1. Write the port A and port B control registers (PACNT and PBCNT) to configure SCC2
2. Write SIMODE to configure the SCCs physical interface.
3. Write SIMASK if IDL or GCI multiplexed mode was selected in SIMODE.
4. Write RFCR/TFCR.
5. Write MRBLR.
6. Write SCON.
7. Write SCM without setting the ENR and ENT bits.
8. Write DSR.
9. Write SCCE with $FF to clear any previous events.
10. Write SCCM.
11. Write IMR.
12. Write the Rx buffer descriptor control/status, buffer pointer high, and buffer pointer low
13. Prepare transmit buffers as required to transmit data on the SCC. Set the R bit in each
14. Write SCM, setting the ENR and ENT bits to enable reception and transmission on the
15. Prepare more transmit buffers as required to transmit data on the SCC.
1. Read the SCC event register.
2. Clear any unmasked bits that will be used in this interrupt routine.
3. Handle the interrupt events as required by the system.
4. Clear the appropriate SCC bit in the in-service register (ISR) of the interrupt controller.
5. Return from the interrupt.
or SCC3 serial interface pins as peripheral pins, if SCC2 or SCC3 is used.
words for all of the buffer descriptors that are going to be used. Set the W bit in the last
buffer descriptor to be used in the queue.
Tx buffer descriptor's control/status word when the data buffer is ready for transmis-
sion. Set the W bit in the last Tx buffer descriptor in the table so that the IMP will use
the first Tx buffer descriptor (after the user sets the R bit) for the next transmission.
SCC.
MC68360 USER’S MANUAL
SCC Programming Reference
E-41