MC68302EH20C Freescale Semiconductor, MC68302EH20C Datasheet - Page 260

• Manufacturer Part Number: MC68302EH20C
• Description: IC MPU MULTI-PROTOCOL 132-PQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68302EH20C

• Processor Type: M683xx 32-Bit
• Speed: 20MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 132-MQFP, 132-PQFP
• Family Name: M68000
• Device Core: ColdFire
• Device Core Size: 32b
• Frequency (max): 20MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 5V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 132
• Package Type: PQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Compliant

Communications Processor (CP)
Bit 7—This bit is reserved and should be set to zero.
SMD3–SMD0—SMC Mode Support
LOOP—Local Loopback Mode
EN2—SMC2 Enable
EN1—SMC1 Enable
4.7.3 SMC Commands
The following commands issued to the CP command register (see 4.3 Command Set) are
used only when GCI is selected for the serial channels physical interface.
TRANSMIT ABORT REQUEST Command
TIMEOUT Command
4.7.4 SMC Memory Structure and Buffers Descriptors
The CP uses several memory structures and memory-mapped registers to communicate
with the M68000 core. All the structures detailed in the following paragraphs reside in the
dual-port RAM of the IMP (see Figure 3-4). The SMC buffer descriptors allow the user to
define one data byte at a time for each transmit channel and receive one data byte at a time
for each receive channel.
4-140
This receiver command may be issued when the IMP implements the monitor channel
protocol. When issued, the IMP sends an abort request on the A bit.
This transmitter command may be issued when the IMP implements the monitor channel
protocol. It is issued because the device is not responding or because GCI A bit errors are
detected. When issued, the IMP sends an abort request on the E bit.
X00X = GCI—The monitor channel is not used.
001X = GCI—The monitor channel data and the A and E control bits are internally
101X = GCI—The monitor channel data and the A and E control bits are received and
X100 = IDL—The M and A channels are in hunt-on-zero mode.
X101 = IDL—Only the M channel is in hunt-on-zero mode.
X110 = IDL—Only the A channel is in hunt-on-zero mode.
X111 = IDL—Regular operation; no channel is in hunt-on-zero mode.
0 = Normal mode
1 = Local loopback mode. In GCI mode, EN1 and EN2 must also be set.
0 = Disable SMC2
1 = Enable SMC2
0 = Disable SMC1
1 = Enable SMC1
controlled according to the monitor channel protocol.
transmitted transparently by the IMP.
MC68302 USER’S MANUAL
MOTOROLA