SAM9M10 Atmel Corporation, SAM9M10 Datasheet - Page 543

• Manufacturer Part Number: SAM9M10
• Manufacturer: Atmel Corporation

Specifications of SAM9M10

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: Yes
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

31.7.9
31.7.9.1
Figure 31-55. Normal Mode Configuration
31.7.9.2
Figure 31-56. Automatic Echo Mode Configuration
31.7.9.3
Figure 31-57. Local Loopback Mode Configuration
6355D–ATARM–7-Sep-11
Test Modes
Normal Mode
Automatic Echo Mode
Local Loopback Mode
The USART can be programmed to operate in three different test modes. The internal loopback
capability allows on-board diagnostics. In the loopback mode the USART interface pins are dis-
connected or not and reconfigured for loopback internally or externally.
Normal mode connects the RXD pin on the receiver input and the transmitter output on the TXD
pin.
Automatic echo mode allows bit-by-bit retransmission. When a bit is received on the RXD pin, it
is sent to the TXD pin, as shown in
the TXD pin. The RXD pin is still connected to the receiver input, thus the receiver remains
active.
Local loopback mode connects the output of the transmitter directly to the input of the receiver,
as shown in
the receiver and the TXD pin is continuously driven high, as in idle state.
Figure
Transmitter
Transmitter
Transmitter
Receiver
Receiver
Receiver
31-57. The TXD and RXD pins are not used. The RXD pin has no effect on
Figure
1
31-56. Programming the transmitter has no effect on
RXD
TXD
RXD
TXD
RXD
TXD
SAM9M10
543