SAM9M10 Atmel Corporation, SAM9M10 Datasheet - Page 534

• Manufacturer Part Number: SAM9M10
• Manufacturer: Atmel Corporation

Specifications of SAM9M10

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: Yes
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

31.7.8.13
31.7.8.14
31.7.8.15
31.7.8.16
31.7.8.17
31.7.8.18
534
SAM9M10
LIN Errors
Bit Error
Inconsistent Synch Field Error
Parity Error
Checksum Error
Slave Not Responding Error
This error is generated when the USART is transmitting and if the transmitted value on the Tx
line is different from the value sampled on the Rx line.
If a bit error is detected, the transmission is aborted at the next byte border.
This error is generated in Slave node configuration if the Synch Field character received is other
than 0x55.
This error is generated if the parity of the identifier is wrong. This error can be generated only if
the parity feature is enabled (PARDIS = 0).
This error is set if the received checksum is wrong. This error can be generated only if the
checksum feature is enabled (CHKDIS = 0).
This error is set when the USART expects a response from another node (NACT = SUB-
SCRIBE) but no valid message appears on the bus within the time frame given by the maximum
length of the message frame, TFrame_Maximum (see
if the USART does not expect any message (NACT = PUBLISH or NACT = IGNORE).
Section
31.7.8.12). This error is disabled
6355D–ATARM–7-Sep-11