SAM9M10 Atmel Corporation, SAM9M10 Datasheet - Page 1380

• Manufacturer Part Number: SAM9M10
• Manufacturer: Atmel Corporation

Specifications of SAM9M10

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: Yes
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

50.2.4
50.2.4.1
50.2.5
50.2.5.1
50.2.6
50.2.6.1
50.2.6.2
1380
SAM9M10
Pulse Width Modulation Controller (PWM)
Static Memory Controller (SMC)
Serial Synchronous Controller (SSC)
PWM: Zero Period
SMC Delay: Access
SSC: Data sent without any frame synchro
SSC: Unexpected delay on TD output
Perform the ECC by software.
It is impossible to update a period equal to 0 by using the PWM_CUPD register.
None
In this document, the Access is “Read-write” in the Register Mapping Table (SMC_DELAY1 to
SMC_DELAY8 rows), and in the SMC DELAY I/O Register.
The current access is “Write-only”.
None
When SSC is configured with the following conditions:
The data is sent but there is not any toggle of the TF line
Transmit STTDLY must be different from 0.
When SSC is configured with the following conditions:
Unexpected delay of 2 or 3 system clock cycles is added to TD output.
None
• RF is in input,
• TD is synchronized on a receive START (any condition: START field = 2 to 7)
• TF toggles at each start of data transfer
• Transmit STTDLY = 0
• Check TD and TF after a receive START,
• TCMR.STTDLY more than 0
• RCMR.START = Start on falling edge/Start on Rising edge/Start on any edge
• RFMR.FSOS = None (input)
• TCMR.START = Receive Start
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
Problem Fix/Workaround
6355D–ATARM–7-Sep-11