SAM9M10 Atmel Corporation, SAM9M10 Datasheet - Page 1253

• Manufacturer Part Number: SAM9M10
• Manufacturer: Atmel Corporation

Specifications of SAM9M10

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: Yes
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

• SBE: Stream Buffer Empty
0: Stream Buffer is not empty
1: Input Stream Buffer is empty but the picture is not ready.
Software must provide a new stream pointer to hardware. Hardware will not self-reset.
• ASOD: ASO Detected
0: No ASO detected.
1: Interrupt status flag ASO detected.
Hardware has encountered Arbitrary Slice Order tool in the input H.264 stream data, and software must perform entropy
decoding. Hardware will self-reset.
• ISE: Input Stream Error
0: No error.
1: Interrupt stream error occurs.
When high, hardware has encountered a bit error in the input stream data, and software must perform error concealment.
Hardware will self-reset.
• JPEGSD: JPEG Slice Decoded
0: No decoding.
1: JPEG slice decoded.
Hardware has decoded the requested amount of macroblock rows of a JPEG picture.
When high, the SW must set a new base address for the decoder output. Hardware will not self-reset.
• TO: Timeout
0: No timeout.
1: Timeout occurs.
When high, decoder has made no bus transactions in 2
out interrupting is enabled. This should be considered as an encountered error in the input stream.
Note:
6355D–ATARM–7-Sep-11
Post-processor transactions affect this feature; running stand-alone post-processing while decoding may prevent decoder time-
out interrupts.
18
-1 clock cycles and has not set an interrupt. Possible only if time-
SAM9M10
1253