LPC1810FET100,551 NXP Semiconductors, LPC1810FET100,551 Datasheet - Page 922

• Manufacturer Part Number: LPC1810FET100,551
• Description: IC MCU 32BIT 136KB FLSH 100TFBGA
• Manufacturer: NXP Semiconductors
• Series: LPC18xxr

Specifications of LPC1810FET100,551

• Core Processor: ARM® Cortex-M3™
• Core Size: 32-Bit
• Speed: 150MHz
• Connectivity: CAN, EBI/EMI, I²C, Microwire, SPI, SSI, SSP, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, I²S, Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 64
• Program Memory Size: -
• Program Memory Type: ROMless
• Eeprom Size: -
• Ram Size: 136K x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 1x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TFBGA
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

NXP Semiconductors
<Document ID>
User manual
40.8.10 Blank check sector(s) <sector number> <end sector number>
40.8.12 Read Boot Code version number
40.8.13 Read device serial number
40.8.11 Read Part Identification number
Table 854. ISP Blank check sector command
Table 855. ISP Read Part Identification command
Table 856. LPC18xx part identification numbers
Table 857. ISP Read Boot Code version number command
Table 858. ISP Read device serial number command
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by part identification number in ASCII (see
Description
Device
<tbd>
Command
Input
Return Code CMD_SUCCESS followed by 2 bytes of boot code version number in ASCII format.
Description
Command
Input
Return Code CMD_SUCCESS followed by the device serial number in 4 decimal ASCII groups,
Description
I
Start Sector Number:
End Sector Number: Should be greater than or equal to start sector number.
SECTOR_NOT_BLANK (followed by <Offset of the first non blank word location>
<Contents of non blank word location>) |
INVALID_SECTOR |
PARAM_ERROR |
This command is used to blank check one or more sectors of on-chip flash memory.
"I 2 3<CR><LF>" blank checks the flash sectors 2 and 3.
J
None.
“LPC18xx part identification
This command is used to read the part identification number. The part identification
number maps to a feature subset within a device family. This number will not
normally change as a result of technical revisions.
K
None
It is to be interpreted as <byte1(Major)>.<byte0(Minor)>.
This command is used to read the boot code version number.
N
None.
each representing a 32-bit value.
This command is used to read the device serial number. The serial number may be
used to uniquely identify a single unit among all LPC18xx devices.
All information provided in this document is subject to legal disclaimers.
Rev. 00.13 — 20 July 2011
ASCII/dec coding
<tbd>
Chapter 40: LPC18xx flash programming interface
numbers”).
Hex coding
<tbd>
UM10430
© NXP B.V. 2011. All rights reserved.
Table 856
922 of 1164