HD6473258P10 Renesas Electronics America, HD6473258P10 Datasheet - Page 65

• Manufacturer Part Number: HD6473258P10
• Description: IC H8 MCU OTP 32K 64DIP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/325r

Specifications of HD6473258P10

• Core Processor: H8/300
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: SCI, UART/USART
• Number Of I /o: 53
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-DIP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Peripherals: -

3.6.3 Power-Down State
The power-down state includes three modes: the sleep mode, the software standby mode, and the
hardware standby mode.
(1) Sleep Mode: The sleep mode is entered when a SLEEP instruction is executed. The CPU
halts, but CPU register contents remain unchanged and the on-chip supporting modules continue to
function.
When an interrupt or reset signal is received, the CPU returns through the exception-handling state
to the program execution state.
(2) Software Standby Mode: The software standby mode is entered if the SLEEP instruction is
executed while the SSBY (Software Standby) bit in the system control register (SYSCR) is set.
The CPU and all on-chip supporting modules halt. The on-chip supporting modules are initialized,
but the contents of the on-chip RAM and CPU registers remain unchanged. I/O port outputs also
remain unchanged.
(3) Hardware Standby Mode: The hardware standby mode is entered when the input at the
STBY pin goes Low. All chip functions halt, including I/O port output. The on-chip supporting
modules are initialized, but on-chip RAM contents are held.
See section 12, “Power-Down State” for further information.
3.7 Access Timing and Bus Cycle
The CPU is driven by the system clock (Ø). The period from one rising edge of the system clock to
the next is referred to as a “state.”
Memory access is performed in a two-or three-state bus cycle as described below. For more
detailed timing diagrams of the bus cycles, see section 15, “Electrical Specifications.”
3.7.1 Access to On-Chip Memory (RAM and ROM)
On-chip ROM and RAM are accessed in a cycle of two states designated T
and T
. Either byte or
1
2
word data can be accessed, via a 16-bit data bus. Figure 3-13 shows the on-chip memory access
cycle. Figure 3-14 shows the associated pin states.
56