sed1355 ETC-unknow, sed1355 Datasheet - Page 319

• Manufacturer Part Number: sed1355
• Description: Sed1355 Embedded Ramdac Lcd/crt Controller
• Manufacturer: ETC-unknow

Epson Research and Development
Vancouver Design Center
Comments
Program Messages
1355PWR Software Suspend Power Sequencing Utility
Issue Date: 98/10/30
• The /i argument is to be used when the registers have not been previously initialized.
• When using a PC with the SDU1355 evaluation board, the PC must not have more than 12M
• GPIO1 is used to signal when the software suspend mode, hardware suspend mode, or LCD has
• Hardware suspend is changed by reading or writing to a memory address decoded by the PAL on
ERROR: Did not detect SED1355.
The HAL was unable to read the revision code register on the SED1355. Ensure that the SED1355
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument /softwar e was selected more than once. Select /software only once.
ERROR: Already selected HARDWARE.
Command line argument /hardware was selected more than once. Select /hardware only once.
ERROR: Already selected LCD.
Command line argument /lcd was selected more than once. Select /lcd only once.
ERROR: Already selected ENABLE.
Command line argument /enable was selected more than once. Select /enable only once.
ERROR: Already selected DISABLE.
Command line argument /disable was selected more than once. Select /disable only once.
ERROR: Select /software, /hardware or /lcd.
Did not select one of the following command line arguments: /software, /hardware or /lcd .
Select /software , /hardware or /lcd.
ERROR: Select /enable or /disable.
Neither command line argument /enable or /disable was selected. Select /enable or
/disable
bytes of system memory.
been enabled or disabled.
the SDU1355 evaluation board. This PAL is currently only used for PC platforms, so the
SDU1355 evaluation board does not support hardware suspend on embedded platforms.
.
X23A-B-007-02
SED1355
Page 5