sed1355 ETC-unknow, sed1355 Datasheet - Page 297

• Manufacturer Part Number: sed1355
• Description: Sed1355 Embedded Ramdac Lcd/crt Controller
• Manufacturer: ETC-unknow

Epson Research and Development
Vancouver Design Center
1355VIRT Example
Comments
Program Messages
1355VIRT Display Utility
Issue Date: 98/10/30
• When using a PC with the SDU1355 evaluation board, the PC must not have more than 12M
ERROR: Did not find a 1355 device.
The HAL was unable to read the revision code register on the SED1355. Ensure that the SED1355
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL currently supports only one
device.
ERROR: Could not register SED1355FOA device.
A 1355 device was not found at the configured addresses. Check the configuration address using the
1355CFG configuration program.
ERROR: Not enough display buffer memory for ?? BPP.
There was not enough memory for a virtual screen.
1.
2.
3.
4.
bytes of system memory.
Press "b" to change the bit-per-pixel value from 16 to 15 bit-per-pixel.
Repeat step 2 for the following bit-per-pixel values:
16, 15, 8, 4, 2, and 1.
Press <ESC> to exit the program.
Type "1355virt /a" to automatically pan and scroll.
X23A-B-004-03
SED1355
Page 5