mcf5407 Freescale Semiconductor, Inc, mcf5407 Datasheet - Page 128

• Manufacturer Part Number: mcf5407
• Description: Mcf5407 Coldfire Integrated Microprocessor User
• Manufacturer: Freescale Semiconductor, Inc

SRAM Initialization
The mapping of a given access into the RAM uses the following algorithm to determine if
the access hits in the memory:
if (RAMBAR[0] = 1)
if (((access = instructionFetch) & (RAMBAR[7] = 1)) |
ASn refers to the five address space mask bits: C/I, SC, SD, UC, and UD.
4.5 SRAM Initialization
After a hardware reset, the contents of each SRAM module are undefined. The valid bits,
RAMBARn[V], are cleared, disabling the SRAM modules. If the SRAM requires
initialization with instructions or data, the following steps should be performed:
4-4
6
5–1
0
Bits
1. Load RAMBARn with bit 7 = 0, mapping the SRAM module to the desired location.
Clearing RAMBARn[7] logically connects the SRAM module to the processor’s
data bus.
—
C/I,
SC,
SD,
UC,
UD
V
Name
((access = dataReference)
if (requested address[31:n] = RAMBAR[31:n]
Reserved, should be cleared.
Address space masks (ASn). These fields allow certain types of accesses to be masked, or
inhibited from accessing the SRAM module. These bits are useful for power management as
described in Section 4.6, “Power Management.” In particular, C/I is typically set.
The address space mask bits are follows:
C/I = CPU space/interrupt acknowledge cycle mask. Note that C/I must be set if BA = 0.
SC = Supervisor code address space mask
SD = Supervisor data address space mask
UC = User code address space mask
UD = User data address space mask
For each ASn bit:
0 An access to the SRAM module can occur for this address space
1 Disable this address space from the SRAM module. If a reference using this address space is
Valid. Enables/disables the SRAM module. V is cleared at reset.
0 RAMBAR contents are not valid.
1 RAMBAR contents are valid.
made, it is inhibited from accessing the SRAM module and is processed like any other
non-SRAM reference.
Table 4-1. RAMBARn Field Description (Continued)
if (requested address[31:10] = RAMBAR[31:10])
if (ASn of the requested type = 0)
Access is mapped to the RAM module
if (access = read)
if (access = write)
MCF5407 User’s Manual
Read the RAM and return the data
if (RAMBAR[8] = 0)
else Signal a write-protect access error
& (RAMBAR[7] = 0)))
Write the data into the RAM
Description