IPT-DSPBUILDER Altera, IPT-DSPBUILDER Datasheet - Page 36

• Manufacturer Part Number: IPT-DSPBUILDER
• Description: DSP BUILDER SOFTWARE
• Manufacturer: Altera
• Type: DSPr

Specifications of IPT-DSPBUILDER

• Function: DSP Builder
• License: Initial License
• Software Application: IP CORE, DSP BUILDER
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable

2–14
Figure 2–7. Amplitude Modulation Design Example
Add a Clock Block
DSP Builder Standard Blockset User Guide
5. Click OK.
6. Close the Scope.
7. Make connections to connect the complete your design as follows:
To add a Clock block, follow these steps:
1. Select the AltLab library from the Altera DSP Builder Blockset folder in the
2. Drag and drop a Clock block into your model.
3. Double-click on the Clock block to display the Block Parameters dialog box.
4. Set the Clock parameters
Table 2–14. Parameters for the Clock Block
Parameter
Real-World Clock Period
Period Unit:
Simulink Sample Time
Reset Name
Reset Type
Export As Output Pin
a. From the right side of the Mux block to the top left side of the Scope block.
b. From the right side of the StreamMod block to the middle left side of the
c. From the right side of the StreamBit block to the bottom left of the Scope
d. From the bottom left of the Product block to the line between the Bus
Figure 2–7
Simulink Library Browser.
Scope block.
block.
Builder block and the StreamBit block.
shows the required connections.
Preliminary
(Table
2–14).
Value
20
ns
2.5e–008
aclr
Active Low
Off
Creating the Amplitude Modulation Model
© June 2010 Altera Corporation
Chapter 2: Getting Started