MOD5234-100IR NetBurner Inc, MOD5234-100IR Datasheet - Page 704

• Manufacturer Part Number: MOD5234-100IR
• Description: MOD5234 10/100 ETHERNET MODULE
• Manufacturer: NetBurner Inc
• Type: Controllers & Processorsr

Specifications of MOD5234-100IR

• Interface: I²C, SPI, UART
• Voltage - Supply: 2.5V
• Mounting Type: Surface Mount
• Package / Case: Module
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Format: -
• Baud Rates: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4483564

Debug Support
32.10.5 Data Trace Control Register (DTC)
The DTC register controls which address ranges are enabled for data trace, and if reads and/or
writes are traced in that range.
32-60
22–20
19–2
Bits
1
0
PTEF/
DTEF/
Name
DTEC
PTEC
DTE
—
Table 32-30. WT Field Descriptions (Continued)
Data Trace End. Allows data trace to be disabled at a watchpoint occurrence.
000 Trigger Disabled
001 Data Trace disabled on eTPU Watchpoint 1 occurrence
010 Data Trace disabled on eTPU Watchpoint 2 occurrence
011 Data Trace disabled on Channel Register Write Watchpoint occurrence
100 Data Trace disabled on Host Service Request Watchpoint occurrence
101 Data Trace disabled on Link Register Watchpoint occurrence
110 Data Trace disabled on MRL Watchpoint occurrence
111 Data Trace disabled on TDL Watchpoint occurrence
Reserved
Program Trace Enable Flag (Read). This bit shows if program trace is currently enabled
due to a watchpoint trigger.
0 Program Trace not enabled due to watchpoint trigger
1 Program Trace enabled due to watchpoint trigger
Program Trace Enable Clear (Write). Setting the PTEC bit clears the PTEF flag. This allows
the development tool to turn off program trace started via a trigger without using a second
trigger or module reset.
0 Keep PTEF flag unaltered
1 Clear the PTEF flag
Data Trace Enable Flag (Read). This bit shows if data trace is currently enabled due to a
watchpoint trigger.
0 Data Trace not enabled due to watchpoint trigger
1 Data Trace enabled due to watchpoint trigger
Data Trace Enable Clear (Write). Setting the DTEC bit clears the DTEF flag. This allows the
development tool to turn off data trace started via a trigger without using a second trigger
or module reset.
0 Keep DTEF flag unaltered
1 Clear the DTEF flag
MCF5235 Reference Manual, Rev. 2
Description
Freescale Semiconductor