MOD5234-100IR NetBurner Inc, MOD5234-100IR Datasheet - Page 196

• Manufacturer Part Number: MOD5234-100IR
• Description: MOD5234 10/100 ETHERNET MODULE
• Manufacturer: NetBurner Inc
• Type: Controllers & Processorsr

Specifications of MOD5234-100IR

• Interface: I²C, SPI, UART
• Voltage - Supply: 2.5V
• Mounting Type: Surface Mount
• Package / Case: Module
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Format: -
• Baud Rates: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4483564

Chip Configuration Module (CCM)
If the RCON pin is not asserted during reset, the chip configuration and the reset configuration pin
functions after reset are determined by RCON or fixed defaults, regardless of the states of the
external data pins. The internal configuration signals are driven to levels specified by the RCON
register’s reset state for default module configuration.
If the RCON pin is asserted during reset, then various chip functions, including the reset
configuration pin functions after reset, are configured according to the levels driven onto the
external data pins. (See
on the external configuration pins to allow for module configuration.
9-8
A[23:0], BS[3:0], CS[3:0]
D[31:0], R/W, TA, TEA,
TSIZ[1:0], TS, TIP, OE,
Pin(s) Affected
All output pins
1
2
D[25:24, 21:19, 16],
RCON
CLKMOD1, CLKMOD0
If the external RCON pin is not asserted during reset, pin functions are determined by the
default operation mode defined in the RCON register. If the external RCON pin is asserted, pin
functions are determined by the override values driven on the external data bus pins.
During reset, the external RCON pin assumes its RCON pin function, but this pin changes to
the function defined by the chip operation mode immediately after reset. See
CS0
Table 9-7. Reset Configuration Pin States During Reset
Pin
Table
Table 9-8. Configuration During Reset
9-8) The internal configuration signals are driven to reflect the levels
RCON[4:3] = 00
Configuration
RCON[5] = 1
RCON0 = 0
Default
MCF5235 Reference Manual, Rev. 2
Primary
function
RCON function for all
modes
Not affected
Function
2
Pin
1
Override Pins
in Reset
D[20:19]
00,11
D16
D21
10
01
1
0
0
1
Input
Input
Input
I/O
2,3
Output
State
—
—
—
Output Pad Drive Strength
Must be driven
by external logic
Internal weak
pull-up device
Must be driven by
external logic
1
External with 32-bit port
External with 16-bit port
External with 8-bit port
Chip Mode Selected
Partial strength
Table
Master mode
Boot Device
Full strength
Input
State
Function
Reserved
Freescale Semiconductor
9-8.
4
4