HD64F2218UTF24 Renesas Electronics America, HD64F2218UTF24 Datasheet - Page 684

• Manufacturer Part Number: HD64F2218UTF24
• Description: IC H8S MCU FLASH 128K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2218UTF24

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: 3DK2218-SS - KIT DEV H8S/2218 WINDOWS SIDESHW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

20.12
20.12.1 I/O Port Status
In software standby mode or watch mode, I/O port states are retained. In addition, if the OPE bit is
set to 1, the address bus and bus control signal output are retained. Therefore, there is no reduction
in current dissipation for the output current when a high-level signal is output.
20.12.2 Current Dissipation during Oscillation Stabilization Wait Period
Current dissipation increases during the oscillation stabilization wait period.
20.12.3 Flash Memory Module Stop
Setting of the flash memory module stop mode should be carried out while the programs in the on-
chip RAM and external memory are executed. For details, see section 20.1.3, Module Stop Control
Registers A to C (MSTPCRA to MSTPCRC).
20.12.4 DMAC Module Stop
Depending on the operating status of the DMAC, the MSTPA7 bit may not be set to 1. Setting of
the DMAC module stop mode should be carried out only when the DMAC is not activated.
For details, section 7, DMA Controller (DMAC).
20.12.5 On-Chip Peripheral Module Interrupt
• Module stop mode
• Subactive Mode/Watch Mode
Rev.7.00 Dec. 24, 2008 Page 628 of 698
REJ09B0074-0700
Relevant interrupt operations cannot be performed in module stop mode. Consequently, if
module stop mode is entered when an interrupt has been requested, it will not be possible to
clear the CPU interrupt source or DMAC activation source. Interrupts should therefore be
disabled before setting module stop mode.
On-chip peripheral modules (DMAC and TPU) that stop operation in subactive mode cannot
clear interrupts in subactive mode. Therefore, if subactive mode is entered when an interrupt is
requested, CPU interrupt factors cannot be cleared.
Interrupts should therefore before executing the SLEEP instruction and entering subactive or
watch mode.
Usage Notes