HD64F2218UTF24 Renesas Electronics America, HD64F2218UTF24 Datasheet - Page 259

• Manufacturer Part Number: HD64F2218UTF24
• Description: IC H8S MCU FLASH 128K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2218UTF24

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: 3DK2218-SS - KIT DEV H8S/2218 WINDOWS SIDESHW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

7.4.11
There can be no break between a DMA cycle read and a DMA cycle write. This means that an
external bus release cycle is not generated between the external read and external write in a DMA
cycle.
In the case of successive read and write cycles, such as in burst transfer or block transfer, an
external bus released state may be inserted after a write cycle.
When DMA cycle reads or writes are accesses to on-chip memory or internal I/O registers, these
DMA cycles can be executed at the same time as refresh cycles or external bus release. However,
simultaneous operation may not be possible when a write buffer is used.
7.4.12
When an NMI interrupt is requested, burst mode transfer in full address mode is interrupted. An
NMI interrupt does not affect the operation of the DMAC in other modes.
In full address mode, transfer is enabled for a channel when both the DTE bit and the DTME bit
are set to 1. With burst mode setting, the DTME bit is cleared when an NMI interrupt is requested.
If the DTME bit is cleared during burst mode transfer, the DMAC discontinues transfer on
completion of the 1-byte or 1-word transfer in progress, then releases the bus, which passes to the
CPU.
The channel on which transfer was interrupted can be restarted by setting the DTME bit to 1 again.
Figure 7.21 shows the procedure for continuing transfer when it has been interrupted by an NMI
interrupt on a channel designated for burst mode transfer.
Relation between the DMAC and External Bus Requests
NMI Interrupts and DMAC
Rev.7.00 Dec. 24, 2008 Page 203 of 698
REJ09B0074-0700