HD64F2218UTF24 Renesas Electronics America, HD64F2218UTF24 Datasheet - Page 679

• Manufacturer Part Number: HD64F2218UTF24
• Description: IC H8S MCU FLASH 128K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2218UTF24

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: 3DK2218-SS - KIT DEV H8S/2218 WINDOWS SIDESHW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Timing of Recovery from Hardware Standby Mode:
Drive the RES signal low approximately 100 ns or more before STBY goes high to execute a
power-on reset.
20.6
Module stop mode can be set for individual on-chip supporting modules.
When the corresponding MSTP bit in MSTPCR is set to 1, module operation stops at the end of
the bus cycle and a transition is made to module stop mode. The CPU continues operating
independently.
When the corresponding MSTP bit is cleared to 0, module stop mode is cleared and the module
starts operating at the end of the bus cycle. In module stop mode, the internal states of modules
other than the A/D converter are retained.
After reset clearance, all modules other than DMAC and flash memory are in module stop mode.
When an on-chip supporting module is in module stop mode, read/write access to its registers is
disabled.
When a transition is made to sleep mode with all modules stopped, the bus controller and I/O ports
also stop operating, enabling current dissipation to be further reduced.
Module Stop Mode
STBY
RES
NMI
Figure 20.7 Timing of Recovery from Hardware Standby Mode
t ≥100 ns
Rev.7.00 Dec. 24, 2008 Page 623 of 698
t
OSC
t
NMIRH
REJ09B0074-0700