HD64F2218UTF24 Renesas Electronics America, HD64F2218UTF24 Datasheet - Page 586

• Manufacturer Part Number: HD64F2218UTF24
• Description: IC H8S MCU FLASH 128K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2218UTF24

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 24MHz
• Connectivity: SCI, SmartCard, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: 3DK2218-SS - KIT DEV H8S/2218 WINDOWS SIDESHW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 14 Universal Serial Bus (USB)
14.8.10 Level Shifter for VBUS and IRQx Pins
The VBUS and IRQx pins of this USB module must be connected to the USB connector’s VBUS
pin via a level shifter. This is because the USB module has a circuit that operates by detecting
USB cable connection or disconnection.
Even if the power of the device incorporating this USB module is turned off, 5-V power is applied
to the USB connector’s VBUS pin while the USB cable is connected to the device set. To protect
the LSI from destruction, use a level shifter such as the HD74LV-A Series, which allows voltage
application to the pin even when the power is off.
14.8.11 USB Endpoint Data Read and Write
To write data to an USB endpoint data register (UEDR0i, UEDR1, or UEDR3) on the transmit side
using a CPU word or longword transfer instruction, the size of data to be written must be smaller
than the size of data that is to be transmitted.
For example, when 7-byte data is transferred to the host, 8-byte data is sent to the host if data is
written twice by the longword transfer instructions or if data is written four times by the word
transfer instructions. To write 7-byte data correctly, data must be written once by a longword
transfer instruction, once by a word transfer instruction, and once by a byte transfer instruction, or
data must be written three times by a word transfer instruction and once by a byte transfer
instruction.
To read data from the USB endpoint data register (UEDR0o or UEDR2) on the receive side, the
correct size of data must be read. In this case, the data size is specified by the USB endpoint
receive size register (UESZ0o or UESZ2).
To execute DMA transfer on data in the USB endpoint data register using the on-chip DMAC,
byte transfer musts be used. In word transfer, odd-byte data cannot be transferred. Word transfer is
thus disabled.
14.8.12 Restrictions on Entering and Canceling Power-Down Mode
Before entering the power-down mode, set the USB module stop 2 state. The UDC core must not
be reset.
To access the USB module after canceling power-down mode, cancel the USB module stop 2 state
and wait for the USB operating clock (48 MHz) stabilization time.
Rev.7.00 Dec. 24, 2008 Page 530 of 698
REJ09B0074-0700