HD64F7051SFJ20V Renesas Electronics America, HD64F7051SFJ20V Datasheet - Page 84

• Manufacturer Part Number: HD64F7051SFJ20V
• Description: MCU 5V 256K J-TEMP PB-FREE QFP-1
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7050r

Specifications of HD64F7051SFJ20V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 20MHz
• Connectivity: EBI/EMI, SCI
• Peripherals: DMA, WDT
• Number Of I /o: 102
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 168-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 5 Exception Processing
5.1.2
The exception processing sources are detected and begin processing according to the timing
shown in table 5.2.
Table 5.2
Exception
Reset
Address error
Interrupts
Instructions
When exception processing starts, the CPU operates as follows:
1. Exception processing triggered by reset:
2. Exception processing triggered by address errors, interrupts and instructions:
Rev. 5.00 Jan 06, 2006 page 62 of 818
REJ09B0273-0500
The initial values of the program counter (PC) and stack pointer (SP) are fetched from the
exception processing vector table (PC and SP are respectively the H'00000000 and
H'00000004 addresses for power-on resets and the H'00000008 and H'0000000C addresses for
manual resets). See section 5.1.3, Exception Processing Vector Table, for more information. 0
is then written to the vector base register (VBR) and 1111 is written to the interrupt mask bits
(I3–I0) of the status register (SR). The program begins running from the PC address fetched
from the exception processing vector table.
SR and PC are saved to the stack indicated by R15. For interrupt exception processing, the
interrupt priority level is written to the SR’s interrupt mask bits (I3–I0). For address error and
instruction exception processing, the I3–I0 bits are not affected. The start address is then
fetched from the exception processing vector table and the program begins running from that
address.
Exception Processing Operations
Timing of Exception Source Detection and the Start of Exception Processing
Source
Power-on reset
Trap instruction
General illegal
instructions
Illegal slot
instructions
Starts from the execution of a TRAPA instruction.
Timing of Source Detection and Start of Processing
Starts when the RES pin changes from low to high.
Detected when instruction is decoded and starts when the
previous executing instruction finishes executing.
Detected when instruction is decoded and starts when the
previous executing instruction finishes executing.
Starts from the decoding of undefined code anytime except after
a delayed branch instruction (delay slot).
Starts from the decoding of undefined code placed in a delayed
branch instruction (delay slot) or of instructions that rewrite the
PC.