AT91SAM9G10-EK Atmel, AT91SAM9G10-EK Datasheet - Page 605

• Manufacturer Part Number: AT91SAM9G10-EK
• Description: KIT DEV FOR SAM9G10 ARM
• Manufacturer: Atmel
• Type: MCUr

Specifications of AT91SAM9G10-EK

• Contents: Board, Cables, Power Supply
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Kit Contents: Board
• Svhc: No SVHC (15-Dec-2010)
• Mcu Supported Families: AT91SAM9G10, ARM926EJ-S
• Tool / Board Applications: Microcontroller
• Rohs Compliant: Yes
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

37.5.2.9
37.5.2.10
37.5.2.11
605
AT91SAM9G10
Transmit Data Cancellation
Endpoints Without Dual-Banks
Endpoints With Dual-Banks
Some endpoints have dual-banks whereas some endpoints have only one bank. The procedure
to cancel transmission data held in these banks is described below.
To see the organization of dual-bank availablity refer to
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
– Reset the endpoint to clear the FIFO (pointers). (See,
– Clear TXPKTRDY so that no packet is ready to be sent
– Reset the endpoint to clear the FIFO (pointers). (See,
– Reset the endpoint to clear the FIFO (pointers). (See,
– Clear TXPKTRDY and read it back until actually read at 0.
– Set TXPKTRDY and read it back until actually read at 1.
– Clear TXPKTRDY so that no packet is ready to be sent.
– Reset the endpoint to clear the FIFO (pointers). (See,
Endpoint
Endpoint
Endpoint
Endpoint
Register”.)
Register”.)
Register”.)
Register”.)
Table 37-1 ”USB Endpoint
Section 37.6.9 ”UDP Reset
Section 37.6.9 ”UDP Reset
Section 37.6.9 ”UDP Reset
Section 37.6.9 ”UDP Reset
6462A–ATARM–03-Jun-09
Description”.