HD6433640 HITACHI [Hitachi Semiconductor], HD6433640 Datasheet - Page 111

• Manufacturer Part Number: HD6433640
• Description: H8/3644 Series Hardware Manual
• Manufacturer: HITACHI [Hitachi Semiconductor]

5.7
5.7.1
If the MSON bit in SYSCR2 is set to 1 while the LSON bit in SYSCR1 is cleared to 0, a transition
to active (medium-speed) mode results from IRQ
IRQ
active (medium-speed) mode does not take place if the I bit of CCR is set to 1 or the particular
interrupt is disabled in the interrupt enable register.
5.7.2
Active (medium-speed) mode is cleared by a SLEEP instruction or by input at the RES pin.
5.7.3
Operation in active (medium-speed) mode is clocked at the frequency designated by the MA1 and
MA0 bits in SYSCR1.
102
Clearing by SLEEP instruction
A transition to standby mode takes place if the SLEEP instruction is executed while the SSBY
bit in SYSCR1 is set to 1, the LSON bit in SYSCR1 is cleared to 0, and the TMA3 bit in TMA
is cleared to 0. The system goes to watch mode if the SSBY bit in SYSCR1 is set to 1 and bit
TMA3 in TMA is set to 1 when a SLEEP instruction is executed.
When both SSBY and LSON are cleared to 0 in SYSCR1 and a SLEEP instruction is executed,
sleep (high-speed) mode is entered if MSON is cleared to 0 in SYSCR2, and sleep (medium-
speed) mode is entered if MSON is set to 1. Direct transfer to active (high-speed) mode or to
subactive mode is also possible. See 5.8, Direct Transfer, below for details.
Clearing by RES pin
When the RES pin goes low, the CPU enters the reset state and active (medium-speed) mode is
cleared.
0
interrupts in watch mode, or any interrupt in sleep (medium-speed) mode. A transition to
Active (Medium-Speed) Mode
Transition to Active (Medium-Speed) Mode
Clearing Active (Medium-Speed) Mode
Operating Frequency in Active (Medium-Speed) Mode
0
or IRQ
1
interrupts in standby mode, timer A or