s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 88

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 5: WORK BENCH
5.2.7 Parameter File Generator
The parameter file required for debugging can be created simply by the wb33.
A parameter file is used to set in the Debugger db33 the memory configuration of the microcomputer to be
developed.
[Parameter file generator] window
72
When you click on the [Par gen] button of the execution window, a [Parameter file generator] window
opens up.
Specification of internal memory capacity
Input the internal RAM and the internal ROM capacities respectively in the text boxes for [IRAM size (0,
1,--, 256)] and [IROM size (0, 1,--, 512)] in units of KB. The [IROM size (0, 1,--, 512)] parameter can be
set only in the ICE mode.
Selection of boot address
Choose the radio button [0xc00000] when booting from the external ROM or the radio button [0x80000]
when the system boots from the internal ROM. The boot address is fixed at [0xc00000] except for the ICE
mode.
Selection of external memory area
When using an external memory, input the start address of the area to be used in the text box (in 1MB units)
and choose a memory type (RAM, ROM, I/O, MON) using the radio button. Up to eight external memory
areas can be specified.
The external memory area will be accessed in little-endian format. It can be changed to big-endian format
by choosing [Big]. When [Big] is selected, the simulator mode will process data assuming that the CPU bus
is configured to big endian method. Note, however, that any other mode needs rewriting of the BCU register
in the actual IC to set the bus to big endian. Refer to "Operations of debugging commands" in Section
16.9.11 for the debugger operation.
The S5U1C33104H in-circuit emulator can contain emulation memory for up to 8MB of external memory.
This helps debug a program without having to install memory in the target board. When allocating the
specified external memory area in the emulation memory, check the [Emu] box. When using a device on
the target board, do not check on the [Emu] box. The [Emu] box is available only in the ICE mode.
The simulator mode allows setting of the wait cycle for each area. The set value will be used to display CPU
clock counter in the simulator mode. Refer to Section 16.11, "Parameter File" for more information. The
[Wait] box is available only in the simulator mode.
[Par gen] button
EPSON
Use this window to specify the contents
described below. Then, when you click on the
[Create Par file] button, a parameter file is
created in the current directory.
Debugger mode
Choose a debugger mode from the [Debugger
MODE] combo box. This selection configures
the dialog box so that the necessary information
only can be input.
Parameter file name
Input a file version (v) in the text box for [This
file version (0, 1,--, ff)] and the three low-order
digits (xxx) of a microcomputer type name in the
text box for [Chip name (3 characters)]. When
this is specified, the parameter file is created in
the name "33xxx_v.par".
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL