s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 414

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 16: DEBUGGER
398
(2) When [Source] window is closed
(3) Logging
(4) Successive display
Notes
Source code and line numbers can only be displayed if the srf33 object file that contains the source
information has been read.
Specify the display start address within the range of 0 to 0xfffffff. An error results if this limit is exceeded.
"no map" is displayed for address locations outside the mapped memory area.
If, although source line information is included, the source file cannot be read, a "no source" message is
displayed.
The 16 lines (default) of mixed display are produced in the [Command] window. The db33 then waits for a
command input.
In Format 1, this display begins with the current PC (displayed in the [Register] window); in Format 2, the
display begins with <address>.
The number of display lines in the [Command] window can be changed using the md command.
To save the command execution results to a log file, close the [Source] window and display the results in
the [Command] window. If the [Source] window is open, the display contents will not be saved in the file
because the [Command] window does not display the results.
If you execute the m command after entering it from the keyboard, code can be displayed successively by
entering the [Enter] key only until some other command is executed.
When you hit the [Enter] key, the [Source] window is scrolled one full screen.
When displaying data in the [Command] window, data is displayed for the 16 lines (default) following the
previously displayed address.
Error: Address range (0-0xFFFFFFF).
...Address can be specified using a hexadecimal number or line number.
EPSON
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL