s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 402

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 16: DEBUGGER
386
Notes
The bsq command can only be used in ICE mode.
A sequential break occurs only when all the set conditions are met in the set sequence. The break does not
occur if only part of condition is met.
The break conditions must continuously be specified from condition 1. The bsq command does not allow
settings such as conditions 1 and 3, or conditions 2 and 3. However, it is unnecessary to set three conditions.
The addresses must be specified within the range of the memory area available for each microcomputer
model. An error will result if this limit is exceeded.
If the number of parameters entered in direct input mode is incorrect, an error will result.
If the entered number is illegal or it cannot be recognized as a symbol, an error will result.
The sequential break does not occur in the internal RAM area, since the bus operation cannot be detected from
outside the chip.
Error: Address range (0-0xFFFFFFF).
Error: No map area.
Error: Number of parameter.
Error: Invalid value.
EPSON
...If an address exceeding 0xfffffff is specified.
...If an unused address is specified.
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL