s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 389

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

A hardware PC breakpoint can be set using the [Hard PC break] button of the [Source] window in the same way
as with the bh command explained above.
Click on an address line that you want set (by moving the cursor) in the [Source] window, then press the [Hard
PC break] button. The selected line is set as a hardware PC break point.
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Setting by using the tool bar button
Notes
The addresses must be specified within the range of the memory area available for each microcomputer
model. An error results if this limit is exceeded. In Format 1, guidance is displayed prompting you to input an
address again. In Format 2, the command input is canceled.
When setting a hardware PC break point to extended instructions with ext or delayed branch instructions, only
the first address can be specified.
ext xxxx
ext xxxx
Extended instruction
The hardware PC break function is disabled when the area trace function is set in ICD mode. However, the set
address is maintained and it will be enabled when the area trace function is cancelled.
[Hard PC break] button
Error: Address range (0-0xFFFFFFF).
Error: No map area.
... Can be set.
... Cannot be set.
... Cannot be set.
EPSON
jr*.d xxxx
Delayed instruction
...If an address exceeding 0xfffffff is specified.
...If an unused address is specified.
... Can be set.
... Cannot be set.
CHAPTER 16: DEBUGGER
373