s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 433

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

fle (flash memory erase)
This command erases the contents of the flash memory on the target system.
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Function
Format
Input example
Notes
The fle command can be used only for the flash memory on the target system and cannot be used for the
S5U1C33104H flash memory. Furthermore, simulator mode does not support this command.
To erase the flash memory on the target system, a data write/erase routine must be loaded to the target
memory and the fls command must be executed before using this command. If the erase routine has not been
loaded, an error will result when the fle command is executed.
This command must be executed before writing data to the flash memory on the target system.
When using this command in ICE mode, the S5U1C33104H firmware must be Ver. 2.0 or higher.
fle
Error: Erase routine is not set.
(guidance mode)
EPSON
...Flash start address set by fls
...Undefined address
...Flash start address
...Specify the range to be erased.
...The return value from the erase routine is displayed.
* Press the [q] key to cancel the command.
Start = End = 0: erase all
CHAPTER 16: DEBUGGER
[ICD / (ICE) / MON]
417