s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 403

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

ba (break area)
This command sets, clears, and displays area break conditions.
The following break conditions can be set.
1. Break area (start and end addresses)
2. Break position (inside area or outside area)
3. Bus operation type (read, write, or read/write)
The program breaks after completing a memory access that satisfies the above conditions.
(1) ba
(2) ba <number> <mode> [<side> <address1> <address2> <operation>]
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
(1) Displaying area break conditions
(2) Setting area break conditions
Function
Formats
Input examples
This is the same as condition 1 described in (1). The parameters must be separated with a space.
<number>:
<mode>:
<side>:
<address1>: Start address of area (hexadecimal, symbol or source line number)
<address2>: End address of area (hexadecimal, symbol or source line number)
<operation >: Specify bus operation (1=read, 2=write, 3=read/write)
Condition:
The above is an example where area break 1 is set. The asterisks "********" in area break 2 indicates that
no condition has been set.
Format 1) After displaying the current settings as described in (1), input a command as shown below:
In this example, area break 2 is set. A break occurs when outside the area from address 0x210000 to address
0x21ffff is read.
To quit in the middle of the operation, press the [Enter] key. When the command is suspended, the area
break condition cannot be saved.
Format 2) Input a command as follows:
>
Specify area break number (1 or 2)
Set or clear (1=set, 2=clear)
Specify side of area (1=inside, 2=outside)
0
address1
address2
0xfffffff
EPSON
...Terminated by [Enter] key.
...Specify "area break 2".
...Choose "1. set".
...Choose "2. outside".
...Start address of the area
...End address of the area
...Choose "1. read".
CHAPTER 16: DEBUGGER
(guidance mode)
(direct input mode)
[ICD+MEM33]
387