s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 365

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

w (watch)
This command registers four memory locations as the watch data addresses. Memory contents equivalent to 4
bytes at each watch address are displayed in the [Register] window.
As guidance, the watch data addresses currently set at four locations are displayed sequentially beginning with
the lowest address. Skip the watch address that you do not want to be modified by entering the [Enter] key only.
Enter a new address for the watch address that you want to be modified. You can also use the [^] key (returns to
the previous address) and the [q] key (quit).
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Function
Format
Input example
Notes
When the db33 starts up, four locations at addresses 0, 4, 8, and 0xc are initially set as the watch data
addresses.
The addresses specified here must be within the range of 0 to 0xfffffff. An error results if this limit is
exceeded. Guidance is displayed prompting you to input an address again.
The watch data addresses are set in units of 4 bytes. A warning results if you specify an address that is outside
the word boundary, with your specified address rounded down to a multiple of 4 (lower 2 bits are 0).
Be aware that a value is displayed as the watch data even if an address that is not mapped is registered.
The watch data is displayed in the endian format specified by the parameter file.
w
Error: Address range (0-0xFFFFFFF).
Warning: Round down to multiple of 4.
(guidance mode)
EPSON
...Watch address is input.
...Variable i is specified.
...Not changed.
CHAPTER 16: DEBUGGER
[ICD / ICE / SIM / MON]
349