s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 197

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

11.10.2 Warning
When a warning appears, the assembler will keep on processing, and terminates the processing after displaying a
warning message, unless any other error is produced. An object file and assembly list file will be delivered.
11.11 Precautions
(1) The maximum number of object files that can be linked are 4,000 files including library modules. If this
(2) When performing C source-level or symbolic debugging with the db33, always be sure to specify the -g
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Warning: Numeric range.
Warning: Unknown escape sequence.
Warning: Escape sequence out of range for
Warning: \x used with no following hex digits.
"Warning" is preceded by an input file name and a line number displayed in the form of "<file name>(<line
No.>)." If the source file that includes the debugging information is input, the message is followed by "near
<file name>(<line No.>)." This consists of the original source file name (*.c, *.s) and line number indicated
by the debugging information.
limit is exceeded, an error occurs in the linker.
option before you execute the as33.
Even when the -g option is specified in the gcc33 (the same applies in the case of the pp33), all symbol
information is cut unless the -g option is specified in the as33. The source information is not cut.
Conversely, if the -g option is specified in the as33 but no -g option is specified in the gcc33 (the same
applies in the case of the pp33), symbol information consisting only of symbol names and addresses is
added during assembly. Furthermore, unless the -g option is specified in the lk33, all debugging
information is cut during linkage.
Make sure that the debugging information (debug pseudo-instructions) in the source file is created only by
specifying the -g option of the gcc33 and pp33, and not by any other method. Also be sure not to correct the
debugging information that is output. Corrections could cause the as33, lk33, db33 or dis33 to malfunction.
character.
Warning message
Table 11.10.2.1 List of warning messages
The operand value exceed the specifiable range.
An invalid escape sequence is used in the .ascii pseudo-
instruction.
The character code represented in oct or hex in the .ascii
pseudo-instruction exceeds 0xff.
No value written in hex is found for the hex value specification
in the .ascii pseudo-instruction.
EPSON
Content
CHAPTER 11: ASSEMBLER
181