s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 475

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

Precautions on creating a parameter file
Parameter file created by wb33
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Write each setup item in order of numbers (1) to (11).
Items (1) to (6) and (11) cannot be omitted in ICE mode.
In other modes, items (1) and (12) cannot be omitted.
Write item names (e.g., CHIP, IROM) with uppercase letters.
Write each item from the beginning of the line and insert at least one space or tab between
parameters. Parameters required for each item cannot be omitted.
Make sure each memory map is set in units of 256 bytes, and that emulation memory is set in units of 1M
bytes. A warning is generated if nonconforming boundary addresses are specified.
When using S5U1C33001M1, the memory map should be set in units of 32K bytes.
When using a parameter file created by using the [Par gen] button of the wb33, pay attention especially to
the following when you customize it:
Option size (FOPT)
The option size is set to 0. If you are developing a model which has function options, be sure to set the size.
S5U1C33xxxP board version (PRC VER)
The S5U1C33xxxP version is set to "00 ff" so that any desired S5U1C33xxxP board can be used. If you are
using multiple S5U1C33xxxP boards, correct this setting to limit the versions.
Internal I/O area (RAM, IO)
The internal I/O area set by IO is 64K bytes from 0x40000 to 0x4ffff. Correct this setting to suit the I/O
area of the model.
Emulation memory allocation, and external memory and I/O mapping
If you chose an external memory area in the [Parameter file generator] window, these items are set as
follows:
When the [Emu] button is selected:
When the [Emu] button is not selected:
Correct or add memory maps as required for the system you are developing.
Stack area (STACK)
Only when you choose the [RAM] button to specify the external memory, a stack area of 512K bytes
beginning with a specified start address is set. Correct this setting whenever necessary.
S5U1C33001M1 configuration
When [Generate MEM33 information] check box is selected, information on S5U1C33xxxM is produced.
[RAM] button:
[ROM] button:
[IO] button:
[RAM] button:
[ROM] button:
[IO] button:
The emulation memory is configured using EMRAM, and ERAM is set so that the
entire emulation memory area is used as RAM.
The emulation memory is configured using EMROM, and EROM is set so that the
entire emulation memory area is used as ROM.
The emulation memory is configured using EMRAM, and EIO is set so that the entire
emulation memory area is used as I/O.
RAM is set so that the entire area is accessed as a target RAM.
ROM is set so that the entire area is accessed as a target ROM.
IO is set so that the entire area is accessed as a target I/O (same as RAM).
EPSON
CHAPTER 16: DEBUGGER
459