s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 370

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 16: DEBUGGER
16.10.4 Commands to Execute Program
g (go)
This command executes the target program from the current PC address.
(1) g
(2) g <address>
354
(1) Operation of format 1
(2) Operation of format 2
(3) Entering the [Enter] key after break
Function
Formats
Operation
<address>: Temporary break address (hexadecimal, symbol or source line number)
Condition: 0
The same function as this command input can be performed by selecting the [Go] command on the [Run]
menu or the [Go] button on the tool bar.
The target program is executed from the address indicated by the PC. Program execution is continued until
it is made to break for one of the following causes:
In Format 2, a temporary break address can be specified. The break addresses set here remain effective until
some other command is executed.
The same function as this command input can be performed by selecting the [Go to] command on the [Run]
menu or the [Go to] button on the tool bar. In this case, the temporary break address must be specified by
clicking on the desired address line in the [Source] window before the command can be executed. The
address on the line where the cursor is located during execution is the temporary break address.
The target program is executed from the address indicated by the PC. Program execution is made to break
by one of the causes listed in (1) above or when an instruction at the specified temporary break address is
fetched (the break occurs before executing that instruction).
When program execution breaks, the db33 stands by waiting for a command input after displaying a break
status message (see Section 16.13.1).
Example:
When you hit the [Enter] key here, program execution is resumed from the PC address (break address).
Temporary break address settings are also valid.
The set break condition is met
The [Key break] button is clicked (not supported in debug monitor mode)
A map break, etc., occurs
[Go] button
[Go to] button
address
0xffffffe
(direct input mode)
(direct input mode)
...Specification with a line number
...Specification with a symbol
EPSON
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
[ICD / ICE / SIM / MON]
S5U1C33000C MANUAL