s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 48

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 3: SOFTWARE DEVELOPMENT PROCEDURES
(4) Executing from wb33
Precautions
(1) The program to be debugged should be created so that it can be loaded and executed in the free area of the
(2) The debugging functions are restricted compared to the S5U1C33104H. Refer to Chapter 16, "Debugger",
(3) All the S5U1C33000H functions can be used even if the S5U1C33000H is only connected to the COM port
(4) Refer to the "S1C33 Family In-Circuit Debugger Operation Manual" for more information on the
32
1) Start up the system as described above.
2) Start up wb33 and then select the parameter file "\cc33\sample\dmt33005\33104_m.par" on the
3) Select DB33 options on the [Other options] windows.
4) Start up the Debugger using the [DB33] button.
This procedure starts debugging the same as in items (2) and (3) above.
When debugging the program using the S5U1C33000H and S5U1C33209D1 board, observe the precautions
described below.
RAM or the Flash memory on the S5U1C33209D1. The program load address must be specified when
linking since it cannot be specified by the Debugger. See Figure 3.3.2.3 for the S5U1C33209D1 memory
map.
for the functions and commands that are supported by the S5U1C33000H.
using the RS232C cable. The parallel cable should be used to connect the S5U1C33000H to the LPT port
when high-speed file downloading is required. The following shows the typical downloading speed of the
different ports (the values may vary according to the PC used and operating conditions).
Serial transfer: Downloading to RAM
Parallel transfer: Downloading to RAM
S5U1C33000H.
execution window.
ICD, 115200 bps, command file "led.cmd" or "led2.cmd"
Downloading to Flash memory
Downloading to Flash memory
EPSON
7KB/S
30KB/S
20KB/S
8KB/S
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL