s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 481

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

16.13.3 Warning Messages
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
Area10 external memory start address is not
32k byte boundary (XXX).
Cannot set CE break (XXX-XXX).
Cannot set map break (XXX-XXX).
Debugger mode does not match with a target. The debugger mode speified by the option (-icd, -ice, -mon) does not
Duplicate MEM33 address (CE) with memory S5U1C33xxxM address is duplicatd with memory map.
map (XXX-XXX).
Duplicate memory map attribute
(CE break as RAM XXX-XXX).
Emulation memory address is not 1M byte
boundary.
FO size (0-0x4000), map as 0x4000.
FO size should be an even number, map as
0xXXXXXXXX.
Invalid line, move to next valid line.
IROM size (0-0x80000), map as 0x80000.
Line number of source file is invalid.
MEM33 break information was over written
by user program.
MEM33 not found.
Memory map is not 256 byte boundary.
Memory map is not 32k byte boundary
(XXX-XXX).
No debug information.
No source, display on mix mode.
Not found "Return Code".
Number of source line exceeded 65535.
PRC status does not match.
PRC version does not match.
Round down to multiple of 16.
Round down to multiple of 2.
Round down to multiple of 4.
Stack map is not 256 byte boundary.
Warning message
Table 16.13.3.1 Warning messages
Area10 external memory start address is not 32K-byte boundary.
Cannot set CE break to S5U1C33xxxM.
Cannot set CE break to S5U1C33xxxM.
match with the connected target system.
There are ROM, RAM, IO in the same area.
The emulation memory map address in the parameter file is not a
1MB boundary address.
The FO size is incorrect, so it is mapped as 0x4000.
The FO size must be an even number, so it is mapped as
0xXXXXXXXX.
The source line has no address. The next effective address is used.
The IROM size is incorrect, so it is mapped as 0x80000.
The line number is not included in the source file.
Break information may be destroyed by overwriting S5U1C33xxxM
by user program.
S5U1C33xxxM is not found in the address specified parameter file.
The memory map (.par file) must be specified in 256-byte units.
Memory map is not 32K-byte boundary.
The srf33 file does not have the debug information.
There is no source information. The program is displayed in mix
mode.
No return code is found in the program.
The line number is out of the range.
The S5U1C33xxxP board status is different from the parameter file.
The S5U1C33xxxP board version is different from the parameter file.
The input address is adjusted to a 16-byte boundary.
The input address is adjusted to a 2-byte boundary.
The input address is adjusted to a 4-byte boundary.
The stack map (.par file) must be specified in 256-byte units.
EPSON
Content
CHAPTER 16: DEBUGGER
(alphabetical order)
465