s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 441

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

• The trigger address must be specified within the range of the memory area available for each microcomputer
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
(1) Displaying current setup contents
(2) Changing settings
Input examples for ICD mode
Note for ICD mode
model. An error results if this limit is exceeded. In this case, the system brings up a guidance for entering
addresses again.
The hardware PC break function is disabled when the area trace function is set. However, the set hardware PC
break address is maintained and it will be enabled when the area trace function is cancelled.
When the tm command is executed, the current setup contents are displayed first.
According to the guidance that appears after the current setup contents are displayed, input or choose the
desired new setup contents.
Setting all trace mode
In this example, all trace mode is selected, overwrite to the trace memory is enabled and the counter display
mode is set to instruction units.
Setting area trace mode
In this example, the trace mode and the time measurement mode are set to "area". The trace range is set to
0x600000–0x60010 and break at 0x600100 is enabled. The clock count in the trace information will be
displayed with the accumulated value.
To quit in the middle of guidance, press the [q] key and then the [Enter] key. When the command is
suspended, already specified contents are validated.
To return to the immediately preceding guidance, press the [^] key and then the [Enter] key.
To skip a guidance, press the [Enter] key.
Error: Address range (0-0xFFFFFFF).
Error: No map area.
EPSON
...or "all"
...or "yes"
...or "area"
...or "off"
...or "each instruction"
...Press [q ] if you do not change any settings.
...If an address exceeding 0xfffffff is specified.
...If an unused address is specified.
...Choose "1.all".
...Choose overwrite condition.
...Choose counter display mode.
...Choose "2.area".
...Choose time measurement condition.
...Enter trigger address 1.
...Enter trigger address 2.
...Enable/disable address 2 break function.
...Choose counter display mode.
CHAPTER 16: DEBUGGER
425