s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 396

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 16: DEBUGGER
Choose the [Hard PC...] command from the [Break] menu. The following dialog box will appear.
Enabling/disabling a breakpoint
Only the first two break addresses registered can serve as valid breakpoints. The valid breakpoints are marked by
a suffix /E1 or /E2 attached to the address in the list. Similarly, invalid breakpoints are marked by a suffix /D.
To change an invalid breakpoint to a valid breakpoint or vice versa, select the address to be changed and click the
[Enable] or the [Disable] button. The [Enable] button is effective for only the first two breakpoints. To enable the
third or subsequent breakpoint in the list, disable one of the valid breakpoints first and then set the breakpoint to
be enabled.
380
(5) Clearing a break address
Setting breakpoints from menu
Format 1) After displaying the current settings, input the following command:
An error results if you specify a breakpoint number that has no address set.
To quit in the middle of guidance, input only the [Enter] key and nothing else.
Format 2) Input the following command:
...Clears break address No. 1.
...Break address No. 1 has had its setting cleared.
Registering a break address
Enter an address in the [Break at] text box and press the [Enter]
key or click the [Set] button. If two valid breakpoints already exist
at this time, the new address is registered as an invalid breakpoint.
Only two breakpoints can be enabled at a time. A symbol may be
used to enter the address to be registered.
Clearing a breakpoint
Select the address you want to clear from the [Breakpoint list] box
and click the [Clear] button.
EPSON
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
...Input a break address number to be cleared.
...Choose "4. clear".
S5U1C33000C MANUAL